|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
July 16th 03, 02:54 AM
|
|||
|
|||
Veeduber wrote in message . If you use it on a riveted
aluminum tank, it works best if the tank is first etched with a mild solution of phosphoric acid I have a steel tank that leaves a bit of rust in the filter. Will sloshing the tank solve the rust problem? If so, what compound do you recommend for steel and should it be etched with anything beforehand? D. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode