|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 14th 04, 01:34 PM
|
|||
|
|||
7075 T6 Angle
I am working with plans circa 1963 that call out 7075 T6 1" angle.
Anyone know if it's still manufactured? Don't see it in ACS or Wicks. Thanks, Clark 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
| turbine propeller | sebastian | Home Built | 19 | March 21st 04 12:47 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |
| Another angle... | tongaloa | Home Built | 0 | February 27th 04 11:13 PM |
| FS: Wing spar angle extrusions | Bob Kuykendall | Home Built | 0 | September 25th 03 08:23 PM |
Threaded Mode