![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
![]()
"Frode Berg" wrote in message ...
Hi! We just got the bill for our new engine.....*GASP** It should be ready and mounted in a few weeks. It's a 1968' Piper Arrow 180 hp. Great plane! Is there anything we should be aware of the first few hours running a newly installed factory overhauled engine? It's a Lycoming. Any bad things to look for? Not run it over a speceific RPM or anything like this? Thanks, Frode Berg LN-LMR Hi Frode I have had the opportunity of breaking in a number of new engines on both airplanes and helicopters. The first 25 hours are critical as the rings get seated and the cylinder walls get polished to fit as well as other moving parts. With the break-in oil, keep in mind you are going to have lots of minute particles as the engine wears off the ragged (microscopic) edges which in turn act like grinding compound. Don't hesitate to use full power for the appications such as take-off, climb, or emergency. While at your cruise altitude change the RPM or MP every :10 or so to a higher or lower setting and let it run at that for :10, etc etc. Be sure to check the oil before and after every flight to insure both the quantity and for any chunks that may have partial numbers on them! Go with the manufacturers recommendations in case you have to make a complaint or get a warranty replacement. It has always seemed to me the first 100 hours of an engines life tells the tale of the next 1000. I've had a couple engines fail in the first 100 hours (including turbine that gave up after 23 hrs), and I've taken engines well past the TBO with little or virtually no oil consumption by using the above technique. Turbines of course are a different animal entirely. All in all, religious oil and filter changes are the key to a long running engine and reliability. The same applies to my cars and they keep on running long after they are supposed to like the Energizer Bunny. As a utility pilot, I run my equipment hard in places where help is remote if available at all, and need to depend on it to stay alive. Best of luck Ol Shy & Bashful |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ROP masking of engine problems | Roger Long | Owning | 4 | September 27th 04 07:36 PM |
Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 06:42 PM |
My Engine Fire!! | [email protected] | Piloting | 21 | April 2nd 04 05:02 PM |
Real stats on engine failures? | Captain Wubba | Piloting | 127 | December 8th 03 04:09 PM |
Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |