|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 30th 04, 02:35 PM
|
|||
|
|||
Vacuum pressure
At what rpm do people see their vacuum pressure drop below an acceptable
level(3.2?). I also have a standby vac with a low vac pressure red warning light. When I reduce power to 1200-1300 rpm the vac pressure drops off and the red light comes on. I thought in the past the pressure would hold until around 1000 rpm. Does this seem to be working properly? TIA, Pete 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vacuum pressure | Peter MacPherson | Instrument Flight Rules | 1 | May 30th 04 04:01 PM |
| Cabin Pressure Altitude | Greg Esres | Piloting | 4 | March 24th 04 08:35 PM |
| Vacuum "pressure" for gyros | Jari Kaija | Home Built | 3 | March 18th 04 05:08 PM |
| Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |
| Pressure Differential in heat Exchangers | Bruce A. Frank | Home Built | 4 | July 3rd 03 05:18 AM |
Threaded Mode