|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 6th 04, 12:57 AM
|
|||
|
|||
Clearing a fouled plug
Should you clear a fouled plug on run up with the mag on "Both" or switched
to the side that is running rough? Since it's just heat, I can't think of any reason why one way would be better than the other. -- Roger Long 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pilot/Owner Signoff for spark plug maintenance? | John Clonts | Owning | 3 | September 14th 04 11:08 AM |
| Helicopter headset plug - help needed | NewsGroups | Home Built | 4 | September 8th 04 05:21 PM |
| wiring a mic plug | S Green | Owning | 2 | February 8th 04 11:28 PM |
| Plug in voltmeter | Bob | Owning | 12 | December 27th 03 01:00 PM |
| WTB: Turbine ignition exciter unit, single plug | Juan E Jimenez | Aviation Marketplace | 0 | August 25th 03 12:48 AM |
Threaded Mode