|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 14th 04, 10:37 PM
|
|||
|
|||
Question on Owner Produced Interior parts
I was reading on http://150cessna.tripod.com about owner
manufactured parts. I was wondering if I could make my own interior parts? For example change plastic parts to aluminum, or titanium such as the plastic instrument bezels, mike holder ECT. I have access to a really nice machine shop, CNC equipment, laser cutter's and etchers ect. I can almost make/help make any plastic part on the inside of the airplane out of aluminum or titanium. Any advice on this! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| molding plexiglas websites? | [email protected] | Owning | 44 | February 17th 05 09:33 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Question on Owner Produced Interior parts | NW_PILOT | Owning | 15 | July 16th 04 05:40 AM |
| making the transition from renter to owner part 1 (long) | Journeyman | Piloting | 0 | April 13th 04 02:40 PM |
| Question about corporate insurance. | Captain Wubba | Piloting | 17 | January 27th 04 04:26 AM |
Threaded Mode