|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
July 15th 04, 10:23 AM
|
|||
|
|||
"Richard Lamb" wrote in message So we are going to try brazing the thing,
but first have to remove a pound or so of stickum. Torch it! I used JB Weld to fill in some dished pistons to increase the compression ratio. It worked great for a few minutes until it burned off. D. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is JB Weld electrically conductive? | Scott | Home Built | 14 | July 12th 04 11:24 PM |
| JB Weld or Hi Temp RTV silicone oil crack fix. | Paul Lee | Home Built | 7 | July 12th 04 03:12 PM |
| What is best "JB Weld" type epoxy putty? | [email protected] | Home Built | 4 | March 8th 04 07:45 AM |
| Tube Cluster Weld Question | Dick | Home Built | 6 | January 17th 04 12:10 AM |
| Removing Aerothane | Yosimite Sam | Home Built | 1 | October 18th 03 03:30 PM |
Threaded Mode