![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
Dave, please take a bit more care not to make it look as if I said
something that someone else said. Dave wrote: Sylvia Else wrote: That accident actually has a lot of commonality with the Air Canada flying skidoo accident at Fredericton. Plane put at low altutude with engines at low speed. In both cases, pilots decide to rev up engines to regain altutude (for the airbus, pilot was just showing off, for the skidoos, the pilot aborted landing). In both cases, engines took some time to spin up and produce necessary thrust (nature of turbine engines). In the case of the flying skidoo, because of no FBW, the pilot stalled the aircraft as he tried to climb above trees, and it fell in the snow and traveled in the forest until it hit a tree. In the case of the 320, the computer didn't allow the pilot to raise the nose, avoiding a deadly stall. But the computer didn't know trees were ahead, so plane traveled into the trees. Had the pilot increased thrust earlier, the plane might have regained suffiencty speed to be able to start climbing without stalling and nobody would have noticed anything. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
Military: Pilot confusion led to F-16 crash that killed one pilot | Otis Willie | Military Aviation | 0 | September 1st 04 12:30 AM |
P-51C crash kills pilot | Paul Hirose | Military Aviation | 0 | June 30th 04 05:37 AM |
Fatal plane crash kills pilot in Ukiah CA | Randy Wentzel | Piloting | 1 | April 5th 04 05:23 PM |
AmeriFlight Crash | C J Campbell | Piloting | 5 | December 1st 03 02:13 PM |