|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 18th 04, 02:19 AM
|
|||
|
|||
Hydroforming shops
Does anyone know of a hydroforming shop willing to do small batches
of aluminum parts at a reasonable price? I need about 10 copies of 4 different parts with a 3/8" draw made out of 0.040 2024-0 and a maximum length of 40". Too tedious to do by hand and achieve uniform results. Any suggestions would be appreciated. GaryP 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode