![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#29
|
|||
|
|||
![]()
In article ,
john smith wrote: Unless you have been assigned a lower altitude by ATC, try setting up your pattern so you arrive 1500 feet above field elevation when abeam the approach end of the runway. 1500AGL?? I've done 180 degree desending turns to land and the optimum altitude seems to be about 800AGL. If you start 1/2 mile away from the runway (laterally, abeam the threshold) you're going to follow an arc that's about 3/4 of a mile long. At around 70mph that will take only about 40 seconds, and from 1500' that would require a 2000FPM average descent. -- Ben Jackson http://www.ben.com/ |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
Ivo Prop on O-320 | Dave S | Home Built | 14 | October 15th 04 03:04 AM |
Fwd: [BD4] Source of HIGH CHTs on O-320 and O-360 FOUND! | Bruce A. Frank | Home Built | 1 | July 4th 04 07:28 PM |
IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 07:45 PM |