|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 11th 04, 06:27 PM
|
|||
|
|||
Have you ever seen/made such a flying handcraft?
"Qingpei Hu" wrote in message m... I am thinking on what the rubber powered one looks like... Is it small? gentle? or lovely even. really wanna know these. There was one shown on a programme on TV here in the UK yesterday. Can't remember exactly, but I think it was on Channel 5, and it was about UAVs. (Unmanned Aerial Vehicles). It was about 6" long with fluttering wings fore and aft which twisted in opposite directions...all made out of some very thin plastic/paper covered balsa wood by the look of it. Paul 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie Qs on stalls and spins | Ramapriya | Piloting | 72 | November 23rd 04 04:05 AM |
| Routine Aviation Career | Guy Alcala | Military Aviation | 0 | September 26th 04 12:33 AM |
| Have you ever seen/made such a flying handcraft? | Qingpei Hu | Restoration | 1 | August 17th 04 11:36 PM |
| Have you ever seen/made such a flying handcraft? | Qingpei Hu | Rotorcraft | 1 | August 17th 04 11:36 PM |
| Flying and the New Family | Marco Leon | Piloting | 33 | December 24th 03 06:11 PM |
Threaded Mode