|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 14th 04, 10:49 PM
|
|||
|
|||
AirEd - editing Tbl3D entries?
Hello
does anyone know how to use the hex editor in AirEd to edit Tbl3D tables. My main problem is, I can't figure out how the hex contents of a table are organised. Thx T. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Machinista 2004 - call for entries | Robb Mitchell Machinista.org | Home Built | 0 | February 24th 04 03:19 PM |
| Holding Pattern Entries | Dan Luke | Instrument Flight Rules | 17 | July 11th 03 06:18 AM |
Threaded Mode