|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 25th 03, 10:48 PM
|
|||
|
|||
LS-4A Turbulator tape question
I'm sanding on my LS-4A wings and was wondering several things. Does properly placed ZZ Tape noticeably reduce the high speed drag of an LS-4A? Probably does. Does anyone know the proper location of ZZ Tape on the wings? If it is in the right spot and works, I'll sand around it. If it is not in the correct location, I'll remove and replace it. And if it is reported to have little effect, I'll leave it off. Joe 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question from a new flight student (whopping 7 hours!) | Gary G | Piloting | 90 | October 21st 04 11:48 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Legal question - Pilot liability and possible involvement with a crime | John | Piloting | 5 | November 20th 03 09:40 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
| Special Flight Setup Question (COF) | Dudley Henriques | Simulators | 4 | October 11th 03 12:14 AM |
Threaded Mode