![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Has anyone ever tried using cowling air under the engine as heated air
for carb heat. Because of tight cowling space I am thinking of building a door in the lower cowl for fresh ram air and then closing it and drawing air from under the engine, cooling air coming off the cylinders which seems to run about 120 degrees as my heated air in case of carb ice. I have measured the under engine air on two airplanes now and it seems to run around 120 deg. so this must be fairly typical and would seem to be more than adequite to get rid of carb ice. I have never had the opportunity to measure heated air coming off exhaust manifold. I would build it so fresh ram air is unfiltered and alternate, heated, air would be filtered. in this way I would always taxi using warm filtered air but in normal flight use cold ram air. Makes sense to me, but then so does capitalism. Ray |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat treating 4130 | RAM | Home Built | 0 | July 18th 04 04:33 PM |
Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 12:47 PM |
28 volt pitot heat | B2431 | Home Built | 15 | April 17th 04 03:25 PM |
Heat treating wing ribs | Holger Stephan | Home Built | 13 | February 3rd 04 11:59 PM |
Carb Temperature Gauge | fly_the_skies | Home Built | 6 | January 14th 04 03:32 PM |