![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello;
I am in the finishing stages of building a LIVP and realize that I have forgotten to allow for the elt. What antenna that would be suitable to place in the tail area (where the top section is fiberglass). Getting a ground plane will be difficult. Is there an alternative way to duplicate the effect of a ground plane? Is there any issue with proximity to com antennas? I have a wire whip 2nd antenna that is in that section as well. Thanks, Gary Rodgers |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Retractable Comm Antenna | Ron Wanttaja | Home Built | 11 | September 6th 04 06:59 PM |
Another antenna question | David Wilson | Home Built | 7 | August 12th 04 10:04 PM |
Antenna ground plane and coax grounding | G. Fred McCutchen | Home Built | 2 | August 8th 04 12:27 PM |
ELT antenna -- Pitts | Al MacDonald | Home Built | 0 | July 15th 04 03:27 PM |
comm's RX antenna | acepilot | Home Built | 5 | March 3rd 04 05:34 PM |