|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
November 11th 04, 03:23 AM
|
|||
|
|||
Jay wrote...
the forces beyond that will be calculated for you... ********** Change "calculated" to "estimated" and you'll be close to correct. If you're doing a non-derivative design and want some hope at all of being close in your estimate you better understand the limitations and assumptions that went into XPlane specifically and blade element theory in general. Dave 'carpe datum' Hyde 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hardware and software for motion platform | [email protected] | Home Built | 0 | November 4th 04 11:57 PM |
| Aircraft Design 1942 flying boats FA | Sally | Home Built | 0 | August 19th 04 07:49 PM |
| amateur design consultant? | Shin Gou | Home Built | 14 | June 30th 04 02:34 AM |
| ANNOUNCEMENT - Flight Dynamics Software | J2 Aircraft Information | Home Built | 3 | June 9th 04 12:52 AM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Home Built | 0 | September 18th 03 06:47 PM |
Threaded Mode