|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
November 16th 04, 03:15 AM
|
|||
|
|||
"John Galban" wrote in message
om... So, does anyone have any recommendations? We're open to suggestions. The local bowling trophy shop will engrave some nice ones for very little cash. The choice of backing materials is very wide - plastic or metal in a variety of colors and finishes. Rich S. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC or Laser cut instrument panel | Bill Daniels | Home Built | 18 | October 16th 04 12:06 PM |
| Panel Lights - Need Help | Barnyard BOb - | Home Built | 2 | May 29th 04 07:51 PM |
| Panel lighting | Corky Scott | Home Built | 5 | March 6th 04 12:22 AM |
| Aluminum instrument panel finish? | Richard Riley | Home Built | 31 | February 4th 04 02:09 AM |
| CAD outline of Rans S6S instrument panel? | Rob Turk | Home Built | 2 | October 21st 03 09:27 PM |
Threaded Mode