|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
September 21st 04, 02:54 PM
|
|||
|
|||
nyone know how to
tell the IPAQ not to charge its internal battery off my glider battery? Todd, I think that depends on which pin you have the power going to. On my Pocket PC and on my Sony Clie, one pin just powers the electronics, another powers the electronics and charges the battery. Your pinout schematic should have that info. Another option is to fully charge the battery the night before. Keep in mind the current draw changes accordingly to the demands of charging. Jim Vincent N483SZ illspam 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Universal IC Chip Programmer $600.00 OBO | NW_PILOT | Piloting | 1 | November 5th 04 02:14 PM |
| Classic RAS posts: Chip Bearden and "pilot relief" | Eric Greenwell | Soaring | 5 | February 20th 04 03:59 AM |
| 24/12 volt DC converter | Victor J. Osborne, Jr. | Products | 1 | February 18th 04 02:11 PM |
| Garmin 430 data chip | PaulaJay1 | Instrument Flight Rules | 6 | December 29th 03 04:43 PM |
| ADC chip detectors | CS_Mike | Home Built | 2 | September 3rd 03 06:26 AM |
Threaded Mode