|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 8th 04, 06:52 AM
|
|||
|
|||
Nimbus 3 turbulators
We are refinishing the outer panels of my Nimbus 3 and want to verify
placement of the turbulator strips....when I bought the glider they were about 1/2 inch in front of the trailing edge (in front of aelirons)....... they did not cover the last 7 feet (approximately) of the outer panel. Any input?? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ASW22 ASH25 or Nimbus 4 sharply needed for rent to Poland on EGC Pociunai | Lenti | Soaring | 0 | March 20th 04 09:59 AM |
| D-KERF Nimbus 3 | tango4 | Soaring | 0 | November 11th 03 10:11 PM |
| TINSFOS - looking for a Nimbus T in Europe somewhere | tango4 | Soaring | 0 | October 2nd 03 10:14 PM |
| Nimbus sailplane question | TJ | Soaring | 2 | September 10th 03 02:50 AM |
| Nimbus 3 opinions | tango4 | Soaring | 2 | August 20th 03 05:24 PM |
Threaded Mode