|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#15
March 10th 05, 11:23 PM
|
|||
|
|||
I've retested using the internal (9v) battery connected to the b40. The
results are the same as when connected to the 12v glider battery circuit. Namely, the b40 is unaffected by the transmit so long as the DAD is not connected to it. I'm endeavoring to obtain an SWR analyzer to measure the radio antenna's performance. Short of that, is there any other way for me to tell if there is too much RFI behind the panel or the DAD just has some problem that is amplifing an acceptable level of RFI? 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode