|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
March 10th 05, 11:45 PM
|
|||
|
|||
John wrote:
I'm endeavoring to obtain an SWR analyzer to measure the radio antenna's performance. Short of that, is there any other way for me to tell if there is too much RFI behind the panel or the DAD just has some problem that is amplifing an acceptable level of RFI? With the PTT pressed, wiggle the antenna coax cable adjacent to the connector on the back of the radio. If the connector is the problem (which is likely), the vario reading should bounce around as you do this... Marc 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode