![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I recently did a flight test of my Lancair 235 testing TAS, true air
speed, vs. the reflex angle of the flaps, i.e. angle of the flaps above the wing surface. The test was flown at 1535 lb, 11,000' density altitude, full-throttle, leaned for max rpm. +8 deg. - 196.2mph; +6 deg. - 199.7mph; +4 deg. - 196.2mph +2 deg. - 189.3mph. The test demonstrated that careful adjustment of the flap reflex angle on Lancair or other aircraft so-equipped can result in higher TAS. The reflex angle is sensitive to IAS and weight. As IAS decreases or weight increases, L/D increases with less reflex, more camber and lower body angle. An additional positive effect is that at the lower body angle, vision over the nose is enhanced! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bending extruded angle | Veeduber | Home Built | 8 | August 29th 04 12:58 AM |
7075 T6 Angle | c hinds | Home Built | 7 | May 17th 04 07:33 AM |
Another angle... | tongaloa | Home Built | 0 | February 27th 04 11:13 PM |
FS: Wing spar angle extrusions | Bob Kuykendall | Home Built | 0 | September 25th 03 08:23 PM |
Flap design question | Chris W | Home Built | 1 | August 4th 03 02:50 PM |