|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
March 27th 05, 06:59 AM
|
|||
|
|||
On 2005-03-27, mindenpilot wrote:
crank with mixture at idle cut off [and the throttle full open] UNTIL it catches, then advance the mixture, and pull the throttle. That way works every time. This works every time for me with an IO-540. Hook the pinkie and ring finger around the throttle, position the thumb over the mixture and just twist when it starts to catch. -- Ben Jackson http://www.ben.com/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbine air start -- too cold? | Juan Jimenez | Home Built | 97 | March 14th 05 06:51 PM |
| Turbine air start -- too cold? | Juan Jimenez | General Aviation | 54 | February 2nd 05 04:14 AM |
| USAF = US Amphetamine Fools | RT | Military Aviation | 104 | September 25th 03 03:17 PM |
| Start Anywhere Cylinder (SSA rules proposal) | Mark Navarre | Soaring | 15 | September 25th 03 01:13 PM |
| Best Software and Hardware for Turn Area Task? | Snead1 | Soaring | 29 | August 13th 03 04:12 PM |
Threaded Mode