|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
January 18th 05, 12:03 AM
|
|||
|
|||
"stol" wrote in message ups.com... The engine is far from stock. It uses a Ford Motorsports block, cocla crank. H beam rods, titaniam valves etc. The best stuff one can buy. It did cost me 12,000+ to build including the redrive but thats far less expensive then a comparable certified 300 hp motor.If you are a true motor head you will appreaciate pics of it. here are a few links of the plane. There are some on Jays, alexisparkinn's site, Beltedairs'site and www.ch701.com. http://www.zenithair.com/stolch801/builder-pics/bh2.jpg http://www.zenithair.com/stolch801/builder-pics/bh1.jpg Firewallforward weight including a three bladed inflight adj prop is less then 420 lbs. A little lighter then a fully dressed 0-360Lyc and twice the power in a detuned state. It is basically a full race sprint car motor capable of 800+ hp so it is just idleing along, Ben Nice looking setup. Where are your radiators and are they and the coolant included in the weight? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fuel flow measurement | khanindra jyoti deka | Home Built | 0 | January 5th 05 05:34 AM |
| advanced fuel flow mesurement system using microcontroller | khanindra jyoti deka | Home Built | 4 | January 4th 05 02:18 AM |
| spaceship one | Pianome | Home Built | 169 | June 30th 04 06:47 AM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 03:57 AM |
| Pumping fuel backwards through an electric fuel pump | Greg Reid | Home Built | 15 | October 7th 03 08:09 PM |
Threaded Mode