|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 4th 05, 04:04 AM
|
|||
|
|||
Lyc IO 360 A1A advice requested
For those of you intimately familiar with this engine (in this case in a
'68 Mooney), what are the "gotchas"? I am looking at an aircraft where the engine is about 2940 hrs since factory zero time remanufacture and 990 hrs SMOH done in 1989. Oil consumption normal at about 5hrs/qt and compressions 76,76,75,77. Any advice on the specific things that might snap back and bite me, including ADs, would be most appreciated. L.D. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| need advice with composite for making glare shield | bubba | Home Built | 1 | July 7th 04 05:44 AM |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 2nd 04 11:15 PM |
| Advice on flying Pitts with Haigh Locking Tailwheel | Ditch | Home Built | 19 | January 4th 04 10:18 PM |
| Advice on Partnerships | Jay Moreland | Home Built | 1 | December 31st 03 12:39 AM |
| Need advice on Aeroquip fittings | Corky Scott | Home Built | 2 | December 12th 03 12:46 AM |
Threaded Mode