![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
My KI-209 VOR/LOC/GS Indicator is averaging about 7 degrees off of calibration
on VOR checks. Its driven by a KX-155 and I'f like to adjust it to within tolerance. I don't have a manual for it but I know the adjustment screw is behind one of the two upper panel mounting screws (I think one is the LOC adjustment and one is the VOR adjustment). Can anyone tell me which screw is for the VOR radial calibration adjustment? Thanks - |
Thread Tools | |
Display Modes | |
|
|