|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
May 9th 05, 08:11 PM
|
|||
|
|||
Jay Honeck wrote: Huh??? On my 230 hp O-470, I cruise at 23-squared, without any fancy engine monitors. Using the "pull-until-it-feels-about-right" method of leaning, I get 12 gph. I can lean to that fuel flow without any undue engine sounds, too. But my EGTs go well over 1500 degrees, and my CHTs push 350 when I do. EGT is irrelavant and 350 is not hot. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode