|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 17th 05, 05:49 PM
|
|||
|
|||
Welding equipment advise
I am gathering the things I need to start building.
Does anyone here have any experience with the portable oxy acetylene setups? Is the typical 20ft^3 Oxygen and 10 ft^3 acetylene configuration too small to be useful when building a fuselage/struts? How many times will you typically have to refill during the building process with these smaller tanks? Thanks 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Must the PLANE be IFR-equipped to fly over17,500? | john smith | Home Built | 11 | August 27th 04 02:29 AM |
| Equipment List Required Documentation | O. Sami Saydjari | Owning | 9 | April 21st 04 02:57 AM |
| Flying when you know there is something wrong with the plane | C J Campbell | Piloting | 26 | January 14th 04 04:38 PM |
| TIG welding video? | Russell Duffy | Home Built | 3 | October 6th 03 05:55 AM |
| Welding techniques for 4130? | Building The Perfect Beast | Home Built | 29 | September 4th 03 08:52 PM |
Threaded Mode