|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 24th 05, 01:56 PM
|
|||
|
|||
Suction mounts for Garmin 296
Looking to get a suction mount for my 296. Is there a better one out
there, other than the RAM Mounts? RAM has a couple to choose from. One is longer than the other. The shorter one only seems to have a ball on one side - does that hinder the ability to angle the display to exactly where you need it? The longer one seems to jet out about 4 inches. Seems to me to be too long. But it has a ball on both sides, allowing more flxibility in moving it around.. It's hard to make a decision based on a website. Has anyone used both of these and willing to share their thoughts? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SOARING article on camera mounts | Charles Petersen | Soaring | 4 | June 25th 05 07:02 AM |
| Camera Mounts & Gliding Photography | Charles Petersen | Soaring | 0 | June 18th 05 10:35 AM |
| Effect of suction on DG | Jay Honeck | Owning | 6 | March 3rd 04 01:12 PM |
| iPaq wiring, cradles and mounts for gliders - Ideas?? | Jim Kelly | Soaring | 12 | December 4th 03 11:45 PM |
| Commercial - New PDA mounts from RAM | Paul Remde | Soaring | 0 | September 11th 03 06:27 AM |
Threaded Mode