|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 5th 05, 03:46 PM
|
|||
|
|||
Slightly O/T for flight simmers. Building my own airport
I have just finished building my own airport for FS2004 using the AFCAD
program and when I go to the airport it works well, all AI traffic use it correctly etc but there are non-airport buildings such as houses on the runways and trees on the taxi-ways. I have downloaded the program *Airport for Windows* as I was told that is how you get rid of the buildings, trees etc but when I go to open ANY BGL file it comes up "File has no valid AFD section" Any ideas? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building an Apis equivalent | Eric Greenwell | Soaring | 1 | November 13th 04 05:05 PM |
| the complete minute by minute timeline on 911 | Krztalizer | Military Aviation | 27 | January 27th 04 05:35 PM |
Threaded Mode