![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
In article , "karel adams"
writes: You sure you could satifsy both? After 50 years of flying?? not to mention ?? years of (---^h^h^h) ??? Karel (sorry just couldn't resist) Bet he would be willing to die trying. :-) Bob Reed www.kisbuild.r-a-reed-assoc.com (KIS Builders Site) KIS Cruiser in progress...Slow but steady progress.... "Ladies and Gentlemen, take my advice, pull down your pants and Slide on the Ice!" (M.A.S.H. Sidney Freedman) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Newbie Question - Vacuum vs Electric | Bill Denton | Aerobatics | 1 | April 15th 04 11:30 PM |
Question - Regarding Canard Pushers... | Tilt | Home Built | 33 | August 10th 03 11:07 AM |
Fairing question... | Tina Marie | Home Built | 5 | July 16th 03 12:18 AM |
Canard static port location | Paul Lee | Home Built | 1 | July 12th 03 02:55 AM |
Brake line design question | Charlie Smith | Home Built | 0 | July 2nd 03 12:31 PM |