![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#17
|
|||
|
|||
![]()
a) it would be very dumb to do it without a major overhaul and an
extensive study of the engine....actually, might be worthwhile to make a replica with modern materials and run that. b) a permit? What is a permit going to do for you? You don't need no stinkin' permit...unless you really need a permit...then you get one. c) there is risk if everything, but historically speaking, firing one up and documenting on video/audio for posterity would be very worthwhile. With the right people (definitely not the mythbusters) taking the proper precautions, running this engine, while a major undertaking, under controled conditions ought to be tried....but only if you are going to do it under near lab conditions. Just my opinion...it isn't an ordinary "motor". BeepBeep wrote: http://cgi.ebay.com/Rocket-Engine-Ge...cm dZViewItem Anybody think this can actually be lit off ? that is - without (a). any tech manual documentation (b). any kind of hazmat permits (presuming it uses some toxic chemicals for fuel). (c). blowing oneself up |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
IF I HAD A ROCKET LAUNCHER | X98 | Military Aviation | 7 | August 13th 04 09:17 PM |
TWO EXTREMELY RARE ROCKET BOOKS ON EBAY - INCREDIBLE ROCKET HISTORY! | TruthReigns | Military Aviation | 0 | July 10th 04 11:54 AM |
U.S. Air Force award of four rocket launches this year is likely to be delayed | Larry Dighera | Military Aviation | 15 | May 14th 04 01:58 PM |
Rocket launching of gliders ? Anyone know if it's been done before ? | Jason Armistead | Soaring | 10 | September 13th 03 08:06 AM |
Rocket Launching of Gliders | Jim Culp | Soaring | 0 | September 7th 03 06:52 PM |