|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
September 8th 05, 02:40 AM
|
|||
|
|||
("Bart D. Hull" wrote)
[snip] Then to top it off, depending on what year the MG was, it was positive or negative ground. Look at the alt wiring BEFORE you connect those cables. I snapped off two lug bolts on my brother's 63? Dodge pickup trying to change a flat. Reverse thread on one side. Doh! Montblack 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camloc Installation Tools | jls | Home Built | 13 | May 7th 04 06:11 AM |
| EAA Chapte Tools | [email protected] | Home Built | 7 | March 8th 04 11:51 PM |
| What tools do you take? | Michael Horowitz | Owning | 31 | March 8th 04 03:53 AM |
| FS: MORE of my aviation parts, tools, instruments on ebay | Bill Berle | Owning | 0 | January 14th 04 10:40 AM |
| Why do you buy Snap-on tools? | Anonymo421 | Home Built | 12 | November 9th 03 10:40 AM |
Threaded Mode