|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
September 26th 05, 10:15 PM
|
|||
|
|||
Peter R. wrote:
Will pulling the unit from the power supply cause it to revert back to its factory-set defaults? Why would that be any different from shutting off the master? When my unit was pulled and repaired by Garmin (which reverted all settings back to their defaults), the avionics shop had to recalibrate my GNS480 with the HSI. Garmin must have reset it. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Washington DC airspace closing for good? | tony roberts | Piloting | 153 | August 11th 05 12:56 AM |
| P-3C Ditches with Four Engines Out, All Survive! | Scet | Military Aviation | 6 | September 27th 04 01:09 AM |
| p3/95 | [email protected] | Military Aviation | 1 | September 27th 04 12:27 AM |
| B29 tail serial number Tarakan WW2 | Joanne Smedley | Military Aviation | 6 | August 13th 03 02:11 PM |
Threaded Mode