|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
October 2nd 05, 12:01 AM
|
|||
|
|||
Why not buy a straight pair and heat and bend to your specs?
"B. Jensen" wrote in message ... Does anyone know of a long nose vise grip plies that is bent 90 degrees? I have a needle nose pliers that is bent 90 degrees at the tips, but I sure could use a locking pliers with the same setup. Thanks, BJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 37 Degree Single vs Double Flared Tubing | Craig Foster | Home Built | 1 | July 21st 04 04:24 PM |
| 37 degree fitting | Ernest Christley | Home Built | 8 | June 17th 04 04:29 AM |
| 90 Degree turn while slipping | ISoar | Soaring | 40 | February 14th 04 11:49 AM |
| Advice on flying Pitts with Haigh Locking Tailwheel | Ditch | Home Built | 19 | January 4th 04 11:18 PM |
Threaded Mode