|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 1st 05, 09:27 AM
|
|||
|
|||
Drilling a solid crankshaft
Drilling a solid crankshaft
Has anyone had experience with a solid Lycoming crankshaft modified (drilled) to open oil passages required to control a constant speed prop? I'm asking for a cousin with a friend who knows a guy with an airboat. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another Lycoming Crankshaft SB | Doug | Owning | 13 | July 20th 05 06:12 PM |
| crankshaft counterweights | Dave Butler | Owning | 10 | February 10th 05 05:08 PM |
| How to drill a cenetered hole in end of solid rod | Scott | Home Built | 21 | November 2nd 04 04:04 PM |
| Solid State Backup AI | Dan Truesdell | Instrument Flight Rules | 20 | January 15th 04 10:53 PM |
| Pictures Showing WWII Rotary Engine Crankshaft Arrangements: Where, Please ? | Bob | Military Aviation | 8 | November 8th 03 07:08 PM |
Threaded Mode