"Movement Area" (airplanes and trucks)

"Movement area" is defined in the Pilot/Controller Glossary. At Renton,
Washington, the whole airport is non-movement except for the runway and the
runup areas. Ground Control will answer if you call, but no calls are
expected. Conflicts between airplanes and vehicles are worked out between
the participants with no input from the tower cab.

Bob Gardner
"Andrew Gideon" wrote in message
online.com...

Landing on 22 at KCDW today (after a fantastic little trip with my wife
shooting photos of the fall colors around our town), I was instructed to
taxi via H to N to RN tie-down. P, the taxiway normally used to reach N
from that point, was closed for construction.

That taxi clearance put me in conflict with a truck. I asked ground for
the
trucks intentions, and was told "I don't know; it's not a movement
area" (he may have said "controlled"; I don't recall the specific
verbiage). I had to move very close to parked aircraft to avoid this
truck, who had the grace to slow down. Somewhat.

Airport operations came on the frequency and told the tower to instruct
the
trucks to stay somewhere (again, I don't recall the specifics). The tower
acknowledged. I added "thanks". The tower then asked if I understood
that
H wasn't a movement area (or some such).

This situation irks me. Can ground control clear me through an area over
which they've no control? I've been cleared *to* uncontrolled areas; not
*through*. Does it become controlled when the taxiway normally used for
that route is closed? Should it?

- Andrew