|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 11th 05, 10:22 PM
posted to rec.aviation.owning
|
|||
|
|||
oil and length of time for break-in
Hi everyone. I have been running straight SAE 40 mineral oil since I had a
cylinder replaced. That was about 15 hours ago. My A&P says that I should think about switching to AD now. The general wisdom has been that switching to AD after break-in should be done after 25 to 50 hours. Since only one cylinder has been off, I don't think I would notice a difference in oil consumption when the rings on the new cylinder are seated. Should I just make the switch now or wait a bit longer? Thanks Matt 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode