|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#20
December 21st 05, 04:09 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
"Must Have" Tools for Christmas
"Dan, U.S. Air Force, retired" wrote I was poking fun, there are machines that require 660 VAC 3 phase, but unless you are turning barrels for gunboats you aren't likely to need one. There would be an advantage to using 660 3 phase, for machines of the size we would use. Wires would be easy to run. You could run a piece of 22 gauge wire, and get all of the power you needed! g -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camloc Installation Tools | jls | Home Built | 13 | May 7th 04 05:11 AM |
| EAA Chapte Tools | [email protected] | Home Built | 7 | March 8th 04 10:51 PM |
| Why do you buy Snap-on tools? | Anonymo421 | Home Built | 12 | November 9th 03 09:40 AM |
Threaded Mode