![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Its annual time here in rainy California,
IA spotted a few spots (about the size of a dime) of incipient corrosion on the prop so he pulled it and sent it off to the prop shop for cleaning and painting (said it probably wouldn't need a full overhaul). OK by me . . . lets always err on the safe side with prop corrosion. That was three weeks ago. Now I've found out that one of the mechs at the prop shop measured the tips and found that the prop might be out of spec -- so pending further review and discussion I may be looking at having to acquire a replacement. I'm a relatively new owner (and still a student pilot). Advise and suggestions needed on how to go about selecting the right replacement. I'm sure I'll get pretty good info from the shop but thought I would ask here first to get my mind focused on the issues. And a question on climb vs cruise props. Which would be a better choice for a plane that operates generally at sea-level, low density altitudes? How would that choice be affected if the plane was to be used to travel cross country over significant mountains (10K or higher). Thanks for the help Chris |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cherokee Pilots Association Fly-In Just Gets Better and Better | Jay Honeck | Piloting | 7 | August 8th 05 07:18 PM |
Propeller for aircraft engine ground test | Guy Deraspe | Home Built | 0 | July 21st 04 04:41 AM |
F4U inverted gull wings | Bob M. | Military Aviation | 52 | July 16th 04 02:11 PM |
Sensenich W72CK-42 propeller for sale | Steven P. McNicoll | Owning | 0 | November 18th 03 03:03 AM |
Sensenich W72CK-42 propeller for sale | Steven P. McNicoll | Aviation Marketplace | 0 | November 18th 03 03:02 AM |