PSRU design advantages

The basics:

Piston engines produce more power per pound if they rev higher. (HP = RPM x
torque/5252)
Propellers are MUCH more efficient if they turn slow.
This begs for a PSRU.
BUT, a PSRU adds weight, cost and complexity.
Resonances, particularly torsional resonances are a real problem.
Lots of examples of PSRU's on 12, 14 and 18 cyinder engines
Few workable examples with fewer cylinders suggesting PSRU's don't like
power pulses.
If a shaft has a strong resonant fundamental, don't excite it or lower the
fundamental below the input frequency.
Tuning a PSRU/shaft/propeller system is like tuning a piano - it's an art
not a science.

"ADK" wrote in message
news:3pGYf.26105$Ph4.10950@edtnps90...
IF you had to design a PSRU, to drive a pusher propellor via shaft, what
would your experience dictate? Thinking along the lines of a gearbelt,
chain or gear. Please, I would appreciate the collective experience
available on this group. I have decided on the aircraft, but want to make
it the most reliable and safest it can be.

"ADK" wrote in message
news:X6TXf.28774$%H.11944@clgrps13...
This is probably going to open old wounds. What I would like is
experienced input on the advantages, for economic, efficiency and
longevity etc. of different types of redrives.

I am leaning towards a cog-belt reducer in a 6 cylinder, liquid cooled,
configuration driving a long drive shaft to the prop.