![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
![]() Robert M. Gary wrote: Its quite depressing to see my plane in so many pieces. I've also discovered that its extreamly irritating that the aircraft parts places are closed on weekends. Agree with your general premise that owner participation is a plus, in a lot of ways. The "parts places closed on weekends" deal"....well, welcome to the aviation industry mindset. I owned two airplanes, from the mid-80s till last year, and I ran into that inconvenience repeatedly over the years, when I became aware I needed stuff, but, the suppliers only were open "banker's hours". So, even though they want usurious prices for what they sell, they'll only do it when it's convenient. I find that attitude quite arrogant. They get away with it, obviously, because they, like all the rest of the aviation "service" industry, are acutely aware that unless you source, procure, and *PAY THROUGH YOUR *NOSE* FOR" all those items necessary for "airworthiness", your airplane is GROUNDED. And, they *know* you don't want to ground your airplane. It's a federally-sanctioned racket. I sold my last airplane. I don't need that frustration. I haven't missed it. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
2006 Annual -- My 8th Owner Assisted -- Update | Jay Honeck | Owning | 14 | March 27th 06 07:11 PM |
molding plexiglas websites? | [email protected] | Owning | 44 | February 17th 05 09:33 PM |
Christmas Annual - long drivel | Denny | Owning | 23 | December 31st 04 08:52 PM |
Which aircraft certification is required for R&D? | Netgeek | Home Built | 5 | November 23rd 04 05:59 AM |
Annual Costs - Take the Pledge | Roger Long | Owning | 25 | February 1st 04 03:41 PM |