![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#7
|
|||
|
|||
![]()
So, even if it had a pressure pump, wouldn't the original question be the
same? i.e. How does a failure(open) in the system produce a high Vacuum/Pressure? This is kind of embarassing for someone like me who "knows everything". ![]() Shields are up, captain. Al G "swag" wrote in message ups.com... I know the guage in the P337 looks like the guage on the Bonanza I used to fly--and that had a pressure pump. The pins would pop out if the pump didn't deliver enough pressure. I fly a P337 and should know if it has vacuum pumps or pressure pumps, but I don't (red face) Al wrote: Hmmm, the little red pins on the gauge that stuck out when stopped, and retracted when we started, said "Vacuum Source". We didn't have vacuum pumps on the Lear, but did on the C-340. Al G. "karl gruber" wrote in message ... All the pressurized airplanes I've flown have "pressure" not vacuum systems. Karl ATP, CFI, ETC "Curator" N185KG "Al" wrote in message news ![]() I had a trip Friday in a 1977 C-337G(pressurized). On the taxi out I noticed the suction gauge was pegged high. The AI erected ok, but the DG required many updates on the way to the run-up area. Pulling on to the runway, we corrected the DG again, by 30 degrees. We flew VFR to Boise, and checked out the new Garmin 530 just installed. Once we got on the ground, the avionics guy, we had along, pulled the access panel in front of the left windshield. On the back of the panel there is a component that looks like the back of an altimeter, only about half as deep. It has a tube labeled "Air IN" and this one had no hose attached. Nearby was a loose hose, which we reconnected. The system worked fine, and we had no more problems. Can anyone explain to me how opening a fault anywhere in vacuum system can deliver a high vacuum? The gauge worked normally, low before start, rising when the engine lit off. Two source indicators both showed a working pump on each engine. I assume the component I was looking at was a regulator, but I fail to see how the fault we found, could give us the indication we saw. Al G (There is another Al on the goup now ![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
terminology questions: turtledeck? cantilever wing? | Ric | Home Built | 2 | September 13th 05 09:39 PM |
Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 11:35 AM |
Nearly had my life terminated today | Michelle P | Piloting | 11 | September 3rd 05 02:37 AM |
Parachute fails to save SR-22 | Capt.Doug | Piloting | 72 | February 10th 05 05:14 AM |
USAF = US Amphetamine Fools | RT | Military Aviation | 104 | September 25th 03 03:17 PM |