37 degree flare, 1/8" stainless

Ah'm a gonna use a buncha 1/8" SS toobin on my fuel injection system on my

314 cid Cont. GPU. ---I'se gotta buncha ole surplus 3/16" preformed pipes
with lotsa flares on 'em--Whack 'em off at a 45% angle bout an inch long &
silver solder em on to the 1/8"--Makes a stouter joint & moves the
vibration away from the flare
fitting back into the 1/8" line--Dat werk 4 U ??

Richard Riley wrote:

I need to make a dozen 37 degree flares in 1/8 stanless line for a
brake system. My flaring tool only goes to 3/16. Spruce has the
"Rolo-flare" tool that goes to 1/8" for $80 or so, but they say it's
not for use with stainless. OTOH, the other vendors that carry the
Rolo-flare don't say anything about stainless. Has anyone used it for
this?

Spruce also has a 1/8" flaring kit for $19, that comes with a flaring
"punch" http://www.aircraftspruce.com/catalo...aringblock.php
is it used with a hammer?

Spruce also has Weatherhead flaring tools that go to 1/8 for SS, but
they're $400. I hate to buy one for so few jobs. Anyone got a used
one for sale, rent or borrowing?