|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 27th 06, 12:56 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Torque for prop bolts
Quick question for the group. When setting the torque on prop bolts (I
have bolts with nuts), if the hole for the cotter pin doesn't line up with the castleated nut at the proper torque setting, is it better to go tighter or looser to get the hole lined up. My gut instinct says tighter, but.... Scott 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torque Value for Mounting an O-320 wide deck. | Ebby | Home Built | 2 | May 31st 06 01:00 AM |
| VW 1.2 Diesel. What does MAX TORQUE 18k-24k mean ??? | Montblack | Home Built | 6 | April 17th 06 07:03 PM |
| Proper Torque for Fuel Fittings | Steve Waltner | Home Built | 10 | February 20th 05 12:46 AM |
| Bolt torque | Neal Fulco | Home Built | 1 | October 16th 04 06:57 AM |
| Prop bolt torque setting | Whunicut | Home Built | 2 | September 4th 03 12:12 PM |
Threaded Mode