RT-359A transponder question

Superb! Thanks.

Wonder if I dare power the encoder from the "Switched A+ OUT" pin. The
ACK manual recomends powering the encoder directly from the mains bus,
but that would require that we pull the fuse/circuit breaker before
startup or install a separate breaker for the encoder. Wonder why they
don´t recommend using the switched output? It´s only a 60mA current
draw, but maybe it is the 420mA warm up current that is the problem...

/Lars

skrev:

Top row of pins are odd #s 1 to 23 right to left. Bottom row are even
#s 2 to 22 right to left.
PIN
3 Remote IDENT Sw
5 Remote IDENT Sw
9 Switched A+ OUT (+LV)
2 GND
11 MODE C COMMON
14 A1
13 A2
15 A4
19 B1
17 B2
16 B4
21 C1
18 C2
20 C4
10 D4
22 A+ INPUT
12 LIGHTING
1 GND
23 PWR JUMPER
8 PWR JUMPER

For 14 VDC operation, connect pins 8 and 23. For 28 VDC operation,
connect dropping resistor between pins 8 and 23. Hope this helps,

Steve

Lars wrote:
Anyone out there who knows the pinout of the rear connector of the ARC
RT-359A transponder? We just got an altitude encoder to go with the
unit (an ACK A-30) in hope for a little better reception from the ATC
when flying in controlled airspace...

The ACK installation manual is fine, giving the pin numbers to connect,
but I don't have the RT-359A manual so I don't know which pin is which.
The connector on the back side of the RT-359A is two staggerd rows of
flat pins, the top one with 12 pins and the bottom one with 11 pins.
There is also two round alignment pins, one on each side of the bottom
row. I haven't got the mounting bracket with the female connector out
yet, maybe the pin numbers are printed on that one, but it is in a
rather awquard place so I don't want to start ripping things apart
until i know how to finish the job.

BTW, the X-ponder is in a Jodel D119, SE-XED.