![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
We were hoping that our prop would last until the city was done
repaving our horrible taxiways. There was no sense in replacing it while we were literally picking up stone chips on every flight. Well, on our first flight after getting back in our own hangar, with our beautiful new taxiways (after fighting for 8 years to get them resurfaced!), we picked up a nice thin sheen of oil on the windshield. We've cleaned everything up, and plan on keeping a close eye on it, but I know we're getting close to needing to do something with the prop -- it's past due in time. We would either go with an overhaul, or now would be the time to install a 3-blade prop, both for inproved smoothness of operation (the Lyc O-540 ain't known for smoothness) and improved ground clearance (we like grass strips). Any input either way would be great. Anyone converted to the 3-blade prop in the Pathfinder/Dakota/Cherokee Six line? Anything good or bad to say would be helpful. Thanks! -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advancement of prop blade in flight, new information | Corky Scott | Piloting | 35 | August 28th 04 02:00 PM |
Survey - 3 blade prop conversion- Cockpit vibration, happy or not | Fly | Owning | 20 | June 30th 04 05:32 PM |
Hartzelll 3 blade prop | Matt Whiting | Owning | 6 | June 15th 04 01:29 AM |
3 blade prop position on 6cyl engine. | Paul Lee | Home Built | 3 | February 26th 04 12:47 AM |
IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |