|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 5th 06, 02:31 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Increase efficiency of rotating shaft.
I am mechanical engineering student . I described one mechanical
engineering situation that is very useful in any kind of mechanical and energy consumed industries. It it is not even in any applied mechanics book. I hope you will try to understand it and use it. Plz visit my website http://energyefficiency.zoomshare.com Jigar Patel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Honda outboards offset crankshaft design - vertical shaft | [email protected] | Home Built | 1 | May 29th 06 08:00 AM |
| High Efficiency APU | fake mccoy | Home Built | 7 | May 24th 06 01:19 PM |
| Washington DC airspace closing for good? | tony roberts | Piloting | 153 | August 11th 05 01:56 AM |
| Counter rotating propellers | Raoul | Military Aviation | 24 | September 21st 04 06:59 AM |
| F4U inverted gull wings | Bob M. | Military Aviation | 52 | July 16th 04 03:11 PM |
Threaded Mode