|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 11th 06, 07:06 PM
posted to rec.aviation.homebuilt,rec.aviation.misc
|
|||
|
|||
Testing spray pattern on turbine injectors
I'm in the middle of cleaning the injectors of the engine on my BD-5J, and I
was wondering if someone here has dealt with this issue before... I need to test spray pattern. The engine has 8 injectors. I know I can set up a rig where I pump fuel into the injectors, and perhaps use a piece of cardboard 12 inches from the injectors to see what the spray pattern looks like after a shot of fuel. I would be looking for uniformity of pattern from all injectors. Am I missing something else I should look for? Juan -- Posted via a free Usenet account from http://www.teranews.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
| UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
| Mini 500, Helicycle, Turbine, Joe Rinke, Rinke Aerospace, Rick Stitt, Conversion, Kit | TurbineMini Richard | Rotorcraft | 0 | January 15th 04 11:48 PM |
| "I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |
| AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Piloting | 25 | September 11th 03 01:27 PM |
Threaded Mode