![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
OK, everyone, since some feel they have to respond to Mxsmaniac's posts, how
about being humane to all of us who don't want to read all of the crap that is following in his wake. It is easy to make a change to your reply, to help us all out. Simply position your cursor in the subject bar after the "" in the subject. Then, type MX, and then continue along your merry way with your post. This MX will allow every post after yours in the thread to be eliminated, by people who use a newsreader that can not filter entire threads, without a marker, but prefer not to read his ignorance and thread hijacking. This tactic has worked well in other groups. Please be kind to others in this group and take the time to help us block him. Thanks, in advance. -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
directional gyro inlet filter | dlevy | Owning | 2 | October 9th 06 03:00 PM |
Pirep: SacSkyRanch Oil Filter Can Cutter | Jim Burns | Owning | 3 | January 1st 06 06:57 AM |
Century IIIB Rate Filter Parts and Schematics | PilotMike2004 | Owning | 1 | January 10th 05 12:01 PM |
Filter element for Frantz filter | Philippe | Owning | 1 | April 20th 04 08:23 PM |
where exactly to put the noise filter | Dico Reyers | Owning | 25 | February 25th 04 03:21 AM |